Garage Door Opener Installation In Few Easy Steps

The procedure of garage door opener installation is normally simple, though suppliers and components may differ. Since these openers are generally mounted by the consumer, installation guidelines are clear. Components are labeled to make certain easy with best garage door opener installer.

This procedure should only take a marginal quantity of time and your opener will be completely operational.

Construct the Opener

Lay out all parts as the directions suggest. Components are typically stamped or may include lettered stickers. The initial step is to put together the rail. Next you will certainly attach it to the opener’s motor head. When the opener has actually been totally put together, the final action is installation.

Attach the Rail to the Header

To perform this action, you will need an 8-foot ladder. Raise your garage and mark it at the acme. Close the garage door.

At the website of the mark, measure up 2 inches. All-time low of the header bracket will be put below, over the facility of the door. Area the header bracket on at the 2nd mark and protect it with 2 wooden lag screws.

With the electric motor upright the floor and the rail inside the header bracket, align the opener setting up on the door. You will certainly need to align the holes on the rail with the header bracket. Move a clevis pin with the bracket and rail to connect.

Mount the Motor

Location the ladder at the rear of the door tracks, in the facility. Location the electric motor on the ladder. Slowly, elevate the garage door until it can be found in contact with the door. As you remain to unlock, the electric motor setting up will be lifted off the electric motor. When the door is completely open, place a 2×4 in between the opener rail and the door.

To do your garage door opener installation appropriate, you will need to secure the hangers to the motor head into the ceiling stuffs. Using the guidelines and wall mounts provided, attach them to the ceiling with lag bolts. After affixing the wall mounts, raise the electric motor head and bolt it to the ceiling hangers.